I am working with a DMV320 mill. The pallet fixture is was not fabricated exactly perfect so I have to place a G68 angle rotation. I have to rotate the coordinates on the XY plane appox. 8.25 degrees clockwise. I've never done this before and was wondering if I might get some advise. Thanks alot.

I am not sure if it the same for Daewoo as Fanuc, the G17 (G18 -G19) is given on a separate line then G68 X..Y... is center of rotation point followed by R rotation angle in + or - deg from 0 to 360. all moves after are rotated until G69.
Al.

I'm sorry. This is a Fanuc control. I do have a G17 already in. I'm just not sure how to write out the 8.25 degrees. Thanks Al.