Has anyone got a post for Fanuc 18i that works with a Mitubishi M-V5Cn please.

For what software?

Psyhomill,
Thanks for your reply , the software I have is Mastercam mill and the Machine Iam using is mitsubishi M-V5Cn with fanuc series 18i-m control.
Hope this help.
Col

Have you tried using the MPFAN.pst post that comes with your MasterCam? Or do you just need some editing to the post to get what you need?

Psychomill,
Thank's again for your reply , yes I have treid MPFAN on my MasterCam and the editing to the post is my other alternative, which I am about have a look at with a bit of help from a work mate , I must confess to not being an expert , I was just looking for a short cut.
Thank's for your help.
Col.

Posts are totally customizable so its probably the way to go. I'm sure someone out there has a "good post" that works for a particular machine, however in many cases, you want a few more things added or some things removed.

If you do need a little help with adding/removing some stuff, there are several of us here that can help you with that. Good luck.

:cheers:

Hy guys
I need a postprocessor for Fanuc Series 18i on Miyano BNE-515 and I am programing in ProE.
Anyone have an idea where can i get it?