ChrisJ
07-04-2005, 12:01 PM
I purchased a Phase II 8" rotary table.
I disassembled everything I could and I am stuck on one area.
I can't seem to figure out how to remove what is holding the worm shaft in. The diagram indicates that there is a 5x6mm set screw and a threaded pin. When I look in the bored hole in the casting with a flashlight all I see is what appears to be a head of a screw or bolt with a round hole in the center. I have tried different size allen wrenches, but I get no bite.
Has anyone taken this table apart, that would know how to remove what they are saying is a set screw?
I left this question for the distributor but have not received a call or email back with the answer.
Chris
I disassembled everything I could and I am stuck on one area.
I can't seem to figure out how to remove what is holding the worm shaft in. The diagram indicates that there is a 5x6mm set screw and a threaded pin. When I look in the bored hole in the casting with a flashlight all I see is what appears to be a head of a screw or bolt with a round hole in the center. I have tried different size allen wrenches, but I get no bite.
Has anyone taken this table apart, that would know how to remove what they are saying is a set screw?
I left this question for the distributor but have not received a call or email back with the answer.
Chris