I kust built my foam Cutter. Should have the electronics kit from hobbycnc tomorrow or Friday. I want to be able to cut planes out of FFF or Depron. I need some advice/Help doing this. Someone point me in the right direction.
1st the drawing, 2nd the clean Up, 3rd the cutting. what is the 3 software that everyone uses to do each step or is there just 1?
Thanks Krashlnd

here's a link to lots of information , although it's in french you should be able to follow it

http://www.teaser.fr/~osegouin/

it worked for me

Dave

Surprised no one bother to translate it yet (chair)

Hi,
If you search Google for French Translation you will find many sites. Some of these will give a free, but rudimentry, translation. I think that the translation is good enough so that you can get the gist of the message.


Ernie

Hi, did you say - electronics kit from hobbycnc - !!!!??? it's out of stock as the web page say!! I need same kit too:)
from where you buy it ?

Looks like he posted in May 2005. I suspect he got it from HobbyCNC.

Sorry for stating the obvious.

Barry

If you need to translate anything, go to google.com and beside the search bar you will see language tools. here you can put in the web url and tell it what to translate to and you are away. You can also put in words from another language and get a meaning.

Later

If you need to translate anything, go to google.com and beside the search bar you will see language tools. here you can put in the web url and tell it what to translate to and you are away. You can also put in words from another language and get a meaning.

Later
Thx that may help
:-)