You can use 3D engraving in Alphacam. It make result as you want.
Trimming angles in Alphacam.
I can not solve the problem with constrained parametric angles in Alphacam.
For the drawing, I'm using 3d polylines. To draw the path of the tool by which it will rise and fall in the corners. Without use work planes.
I can not understand how to draw in the axes in work planes.
Are there other ways to indicate the path of the instrumen- tation so that it rises and falls in the corners. In Artcam there is a function "Trimming an angle" when engraving. In Alphacam, I have to manually draw the path of the tool on the corners. It turns out that something like a closed rectangle with sharp outgoing rays raised up to the desired angle in 3D polylines. It's very tiring to draw. In cconstrained parametric, these corners are stretched incorrectly.
How to draw such angles in axes in work planes or there is another way to solve?
To parameterize a workpiece drawing.
Thank you
Similar Threads:
- Need Help!- Trimming in v24
- Trimming in an assembly
- Need Help!- Trimming surfaces
- router trimming
- Trimming in bobcad
You can use 3D engraving in Alphacam. It make result as you want.
Last edited by Maroslav4; 08-14-2017 at 02:43 PM.
Postprocessors, VBA macros, .NET programming.
www.ccsoftcz.com
Thanks for the response. Tomorrow at work I'll test. While I solved the problem with the help of constrain and manually editing the tool path by points