Post Processor Alphacam Osai 10 Multiax c113

[luix87]

I need to make some holes in zx e yz faces and my post does not give me the right code

i have 2 post processors but neither of which do the right code

I send the post processors

Similar Threads:

• Need Help!- Post processor for Osai control system from Mastercam x4
• Need Help!- Alphacam and Post Processor for OSAI Biesse Arrow FT
• Need Help!- Alphacam e Post Processor for OSAI Biesse Arrow FT
• Need Help!- Alphacam and Post Processor for OSAI Biesse Arrow FT

[Maroslav4]

Could you please send me also Alphacam file? Do you know how was the look right NC code which must generate this post?

[FrankCNC]

Try the 2 attached Posts I modified from your originals to see if either of them work, The code I generated in AlphaCam from these 2 Posts looks correct. Just remove the .txt extension

Regards,

[rolank1]

Hi Frank would you have a post processor for Mastercam Osai 10. I have been unable to find anything. I bought a used Cr Onsrud router and need to get it working. Thanks Kevin