alphacam g41/42 lead in.out

[loopylee]

Hi, i am after some help as trying to nest parts on biesse excel have a lead in/out but when i nest and put post in alphacam comes up with you have g41/g42 offset but some cuts have no lead in/out. So machine code wrong as not reading compensation for tools? any help would be appreciated.
MANY THANKS
LEE

Similar Threads:

• Ramp toolpasth/Lead in-lead out (engage) question
• Need Help!- Help Needed. G540 : Wire a 8 lead stepper to the 4 lead db9
• Newbie- Burn Table Lead in lead out
• Problem- AlphaCAM 00 and AlphaCAM V5 - same postprocessor
• How do you mount a lead screw/lead nut?

[RSmitty]

Make sure machine comp is checked of in the first screen that comes up. You should have three options 1 tool center 2 machine comp 3 g41/42

[loopylee]

Thanks smitty but m/c comp is on gets to nest and put nc code in just some cuts have g41/g42 but no lead in/out

[camnerd]

Attach Your Acam-file.. then it's easier to see what might be wrong...

[Malgiliath]

You need to be looking at the Lead In/Out options from the Machine menu to apply a roll on and off move to allow the compensation to be applied correctly

[lean0882]

Hi, we had Alphacam 7.5 on a PC with Windows XP .The PC broke down we got a new PC with Windows 8 and Alphacam 2015 running but the post processors from Alphacam 7.5 .When we do the tool path we get a message saying (Some cuts have G41/42 off set and no lean-in/out:NC-code will probably be wrong!) . How can we fix it can you help us? I am sending a file from the CNC if necessary for you to see where this failure. thank you very much for the help in advance .