Need Help!- Inverter hookuo

[machine_nut]

I originally posted this as a reply to another thread, sorry about that.
Here is the problem.

I have been building an Ajax Retrofit on a Bridgeport series 1 with and a SJ100 Inverter. I have most every thin done but am getting quit confused with the Inverter manual. I follow the Ajax Schematic an my hookups are this.

CNC7 Inveter

T1 L on Logic side
L1 to Spin Encom
CW 1 on Logic Side
CCW 2 on Logic side

Analog Out L Analog Side
Analog Com 0 Analog Side

The Spindle motor will run from the Run command on the inverter but nothing
when I press the start on the control pendant.
Am I missing some setting on the Inverter?

If any of you have done this with success I would appreciate your help.

[machine_nut]

Originally Posted by machine_nut I originally posted this as a reply to another thread, sorry about that. Here is the problem. I have been building an Ajax Retrofit on a Bridgeport series 1 with and a SJ100 Inverter. I have most every thin done but am getting quit confused with the Inverter manual. I follow the Ajax Schematic an my hookups are this. CNC7 Inveter T1 L on Logic side L1 to Spin Encom CW 1 on Logic Side CCW 2 on Logic side Analog Out L Analog Side Analog Com 0 Analog Side The Spindle motor will run from the Run command on the inverter but nothing when I press the start on the control pendant. Am I missing some setting on the Inverter? If any of you have done this with success I would appreciate your help.

Problem Solved.

[Captain Midnigh]

What did you do?

[machine_nut]

Originally Posted by Captain Midnigh What did you do?

The problem was actually with the the schematics. There is a sectional schematic of the wiring for the inveter that I was using for clarity istead of the full instalation scematic, well as luck would have it the sectional one was drawen wrong and just bacwards of what it was supposed to be, they had the control analog out com going to inverter out instead of inverter in. which I found when compairing the two schematics.