| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| AjaxCNC Control Products Discuss Ajax Control systems and project here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#13
 
08-11-2005, 07:44 AM
| |||
| |||
| The Centroid software runs outside of Windows in DOS. On a typical setup, the computer boots straight to the CNC software and not Windows. The CNC software must be exited before Windows starts up.
__________________ (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)  |
|
#14
08-18-2005, 07:37 PM
| |||
| |||
| I've seen many setups where the software is running inside of windows 98, yeah i know technically 98 is still a dos based system and all sorts of arguements can be made both ways. but if you get down to it, if you just boot into 98 and run the software from there it works fine. |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| G-Code to DXF | WayneHill | OpenSource Software | 200 | 04-22-2012 09:51 PM |
| EdgeCAM Post for Centroid Control | kenmcd | Post Processor Files | 1 | 03-23-2008 08:23 PM |
| Centroid M -400 help needed | densman | Machine Problems, Solutions , Wireless DNC, serial port | 1 | 01-30-2008 02:48 PM |
| 4 axis control board question | cnctoolman | Hobbycnc (Products) | 1 | 04-01-2005 03:30 PM |
| Parallel Port / Relay Control Question | Verboten | Computers and Networking | 7 | 12-21-2004 04:17 PM |
| | |
Linear Mode
