Need Help!- z axis full power without motion

[MILLMANM]

cncsnw
thanks for the info, this morning i have more problems.
to start when getting behind the mill to check it out i rubbed a 120v inlet wire and it starked but did not blow the fuze, but now it may not be related but the system will not boot 2 light on the pennet but no video to the monitor. maybe the motherbord is going out also no light on the flashdrive if it has 1
quess it going to be a long week

[MILLMANM]

The latest . called the motherboard mfg and did some test.
first pull the flashdrive, pci card, memory and reinstalled them 1 at a time to get the screen to the boot page, and after reinstalling everything it all works again the only thing is i did remove the fiber and power cables from the pci card

must have been connection problems maybe but everything is back to normal except the temp in the garage, anybody want to donate to cool may garage haha

thanks

[Joe S.]

Originally Posted by MILLMANM The latest . called the motherboard mfg and did some test. first pull the flashdrive, pci card, memory and reinstalled them 1 at a time to get the screen to the boot page, and after reinstalling everything it all works again the only thing is i did remove the fiber and power cables from the pci card must have been connection problems maybe but everything is back to normal except the temp in the garage, anybody want to donate to cool may garage haha thanks

Switching type power supplies usually are wired to shut down when shorted, the will usually reset after a complete power off shut down, possible yours has some large filter caps which had to have time to discharge before working again.