| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| AjaxCNC Control Products Discuss Ajax Control systems and project here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
01-20-2007, 09:09 AM
| |||
| |||
I've got a Hurco KMBI with the Ajax/Centroid controller. It runs on Linux. I've got a USB hub up by the keyboard so I don't have to open the cabinet every time I want to use my USB drive to bring in a program. Is there any way to get it to recognize a USB mouse?    |
|
#2
02-03-2007, 01:22 PM
| |||
| |||
| The control program doesn't support mice, regardless of their connection. |
|
#3
02-05-2007, 10:13 AM
| |||
| |||
| The AjaxCNC control supports a PS/2 mouse, but the driver must be installed first. Go out to the Linux prompt (<F10> Shutdown, <F6> System Prompt from the main menu) and type "addmouse". Type "exit" to return to the control software and reboot the system. The mouse must be connected while the system is powered down.
__________________ (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Mutilated mouse DRO (using Microsoft PS2 Mice) | wcarrothers | General Electronics Discussion | 6 | 03-30-2009 12:37 PM |
| Mouse problems w/MC9 | Halfnutz | Mastercam | 3 | 10-14-2006 01:27 AM |
| 2D Digitizing using mouse | DennisCNC | Digitizing and Laser Digitizing | 0 | 05-07-2006 11:08 PM |
| Mouse encoders | Rance | General Electronics Discussion | 26 | 02-07-2005 02:46 PM |
| Fun with steppers (From serial mouse to stepper) | Konstantin | General Electronics Discussion | 0 | 07-21-2004 01:41 PM |
| | |
Linear Mode
