No responses yet, so I did a little troubleshooting inside the controller since I am an electronics tech. I did find that the ribbon cable connector on the flat panel screen was loose, secured it and now I have video. The processor boots up in dos, goes to c:\> and I can't get beyond that. Did a directory search and there were only 5 files and saw nothing that resembled CNC software. Can't find an M-15 manual anywhere on the net, so I don't know if that's normal and waiting for a starting command or if indeed the operating software is gone. Once the screen was working I expected the software to automatically load. I have a small bench top mill with an ahah! dos control. I type in "cnc40" after the prompt to load the software.
I have the ball at least rolling. Can anyone give it a kick?
Thanks for your thoughts,
Woody