I have been using the LPT Indexer on my CNCCrafter 36*36
router for about four years. Last year I switched from the HPGL Code Controler to the G-Code Controller which allowed me to use
both BobCad Version 18 and ArtCam Insignia Version 3.
The Ability Systems software works very well. I have had a lot of help from Arthur Volta setting up my system.
i have purchased ability's indexer lpt n g code controller and i have tried running machine on it but it runs at only 1.5 M/min. speed which is very low. anyone out there, familiar enough with software, to help me out with this??? i will give complete driver n motor n pc detail to anyone willing to help.