Looking For Users

[ninewgt]

Hey guys

I am looking for other users of LPT Indexer and G-Code controller. I am using the latest version on my 4 X 8' router (you can see it on this site)

I'll wait to hear from others.........


Thanks

TM

[ninewgt]

I am typing up a full review, tech article and my experiances with Indexer and G-Code Controller to be posted here soon.

Tom

[Richard]

Tom

I would be interested in your review of indexer lpt! Considering using it here for plasma cutting.

Regards....Richard.

[ninewgt]

I still have not gotten around to writing my review - I have been pretty busy with the new machine, plans, etc...

I will say I am very happy with Ability systems software and would reccomend it

[janjecic]

I have been using the LPT Indexer on my CNCCrafter 36*36
router for about four years. Last year I switched from the HPGL Code Controler to the G-Code Controller which allowed me to use
both BobCad Version 18 and ArtCam Insignia Version 3.

The Ability Systems software works very well. I have had a lot of help from Arthur Volta setting up my system.

[indianvirus]

hey guys
i have purchased ability's indexer lpt n g code controller and i have tried running machine on it but it runs at only 1.5 M/min. speed which is very low. anyone out there, familiar enough with software, to help me out with this??? i will give complete driver n motor n pc detail to anyone willing to help.