can anyone give me a idea as to where to start with these Emerson En-208 drives and mgm-340 servo motors I'm not sure of two things off the bat. One being this a 3 axis mill what size power supply do I need and how do distribute the single phase 240 volt main line from the fuse box to all of these drives I wanna use mach 3 software, this is a new build for me and is alot larger than my first stepper system. The other problem I have come to discover iss what kinda of breakout board do I need. I looked at the Ajax system using the MPU11 motion controller and the GPIO4D 3rd party drive It looks simple to wire up all except the part where it says It has to be expanded to 240volt, not sure how this is done either. Any body that has a clue on ideas to solve my problem your input is GREATLY appreciated, please send me a private message though for I'm new to this sight and don't wanna miss a reply thank you |