I am runnung my ajax system on a standard pc board , I did add a little bit more stuff than they suggest celeron 2.6 mhz , 1 gig of ram but the cost for later model stuff was about the same. I am running the linux version and so far so good. and it is an easy install ,being that i am not a electrical wizard. It took me about a week during my spare time
good luck ,
Brad
__________________
IF ITS NOT BROKE YOUR NOT TRYING HARD ENOUGH
Ashes to ashes , dust to dust , If it wasnt for Harleys the fast lane would rust.
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |