Originally Posted by dcook  A HAAS control is fully compatible with FANUC code, no changes are required. |
Exactly.
I used the same post processor for Haas and Fanuc controls on side by side machines. The only difference was the tapping cycle - the Fanuc control needed a M19 to orient the spindle in the line before it and the Haas did not. (I
think it was an M19, but that was about 9 years ago).
Also, the program # can not start with a 9 in a Haas - no 90 or 9056 or 905 or anything. I believe that the Fanuc would.