We just purchased a Behrens laser CB2500 at auction, it came with cbcadcam software for programming. We have all the original 3.5 floppies for software, but it did not come with the dongle to run the software. Does anyone know where we could purchase a dongle for this software or by pass it. I tried contacting megacad that produced the software for Behrens but no reply yet. I am asuming they don't support the software anymore. If not could anyone recommend a suitable inexpensive software for the Behrens laser, needs to interface with FNC5, I have all manuals, PLC, and CFG files |