[AdvantageDesign]

I am not a CNC operator, so bear with me. We are trying to get away from our old DOS program CNCMAIND. We have a Fadal VMC 4020A machine with a CNC88HS controller. Like other posts I have read, we are lacking memory and have been using our DOS program to "Run from disk". I recently downloaded a trial of EditCNC. I can establish a connection with the machine, but receive multiple error messages on the controller. I have contacted EditCNC and they listed some setting suggestions. We are still receiving the errors. I'm not sure how to configure the DNC controls on the machine. Does any one else use EditCNC with this machine and what settings work for you.

Our Software Settings:
Send Header: 84,65,44,49
BaudRate: 38400
DataBits: 7
StopBits: 1
Parity: Even
FlowControl: Xon/Xoff

Send Settings
Replace: 13
Check for %


Thanks,
Joe