Originally Posted by kulk_sd  I have a sinking edm AGIE, Switzerland.Type: BF-h (Servo Hydraulic), these are very straight forward scheme compared to wire edm of similar date. It is regular transistorized plus RC type generator & error signal circuitary. I have traced a part of it on my own & have started it long back. I think you also can follow similar procedure. |
I am trying. I have removed the control panel and am tracing the wiring. In the Control Panel Relays K800, K801, and K802 must be made for Gap Power. But only K801 is coming on by itself. When K800 is mechanically made the "Setting Check light" on the Generator goes out and the Gap power will come on. But then K802 must also be touched to latch in the Servo control from the Generator.
Thanks for replying. Just wondered if anyone had the schematics for the Tool so I don't have to hunt and peck.
TROU