Can you identify this extrusion?

[JTH]

I bought 40' of the extrusion shown below at a metal scrap yard but, unfortunately, I can't figure who made it. I'd like to know so that I could order the appropriate t-nuts and related hardware/brackets.

It's 3.46" square (87.9 mm). I'll post further dimensional details tomorrow.

Any thoughts?

[mxtras]

Item? (I mean the brand name 'Item' extrusion)

Just a guess...

Scott

[joecnc2006]

I bought 40' of the extrusion shown below at a metal scrap yard but, unfortunately, I can't figure who made it. I'd like to know so that I could order the appropriate t-nuts and related hardware/brackets.

It's 3.46" square (87.9 mm). I'll post further dimensional details tomorrow.

Any thoughts?

http://stores.ebay.com/8020-Inc-Garage-Sale

or

http://search.stores.ebay.com/faztek

either of these two, the slots are standard sizes.

make sure to measure the center, because the ends are tapperd down.


Joe

[HeyJayC]

I belive this is made by Bosch i have simialar, i think it;s 45mmx45mm.