 Tornos ENC-167 Fanuc Ladder | |
We just purchased a Tornos ENC-167 that was working fine until we set it up in our shop and proceeded to chase down alarms, starting out with a 972 slot 2 alarm, then servo alarms, then a parity alarm.
Under apparently incorrect assumptions, control boards were pulled and "Delete + Reset" was performed. Now, I understand that in doing this (sad to say), parameters were erased. But also, the Ladder is not showing up on the monitor.
When I go to SYSTEM->PMC, I get "ER07 OPTION (Ladder Step)"
Isn't the Ladder written to eprom? If so, wouldn't that the Ladder still exist?
Any help would be greatly appreciated,
Kenny |