Paul, I tried that last week. I also tried CNCReg.exe, and it didn't work. I also tried reg'ing it via console command line, and every other way I could think of. I finally took the dll from 9.1 and replaced the one from 9.1sp1, now it opens.
CNC Software is aware of the issue. It's covered in depth over at emastercam.
'Rekd
__________________
Matt
San Diego, Ca
___ o o o_
[l_,[_____],
l---L - □lllllll□-
( )_) ( )_)--)_)
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |