I must report, I have been using DeskCNC for years now, never had any problems. Running latest software version v2.0.2.65, with card firmware version v2.36
XP OS, quality components, EMI filters to shield noise coming back from Spindle Controller, EMI filter on Stepper Driver PSU's, EMI filter on SMPS's for DeskCNC 2nd Generation Card, and seperate SMPS and EMI filter for Spindle Speed Controller Interface Card.
Now that I have bragged how well my DeskCNC works, here is a question, anyone know what the G-code command is to switch on the Aux1, Aux2 and Aux3 fuctions? I have always had enough outputs by using Mist, Flood, CW and CCW commands, now I need more.
Thanks for any replies.
Francois |