[bdesh123]

hi everyone
sorry if I am diverting the subject in a diffrent direction. please help me with my tool setup (or tool offset maybe). read the manual couple times. and it helped still need some help. the machine responds to 1600step per sec.. perfectly. the distance of X and Y is traveled perfectly( i guess)
but when i machined a piece of wood. the result was wrong. I asked for 3mm hole came out 4.46mm. Dont know whats wrong please help me.
machine config
Sherline 5410 (metric)
Xylotex with Bpoler 116oz motor. 3axis
useing mach2 6.11 adding the tool table
If i am not wrong. mach2 adds the necessary offsets depending on the tool. then where i am going wrong.
I am adding the faulty part and some other screen shots ... please help
thanks in advance
sami