x dia goes up and down through the day, some mornings i start the machine up and it can give the exactly the same reading as i left it the night before and other morning its can be different.
if im threading it can run fine for hours then ill check another part and the nogo gauge will go in, i will then adjust wear offset and fine for few hours then may do it again.
i go through the day adjusting all the time which isnt right, i would like to run the machine over night unmanned but have no trust in it.
it has been pretty reliable since i bought it new in 2005 but dont think i would buy another one.
my mazak and hitachi just feel so much better machines all round.
whats your thoughts on your haas? |