Hi Martin,
I make musical instrument fittings, accuracy and repeatability are a must.
I can keep my parts within .0015 plus or minus most of the time. That was after I bit the bullet and purchased the Sherline quick change tool, the less expensive other quick change tool I bought first would never re-seat with any accuracy. I am in a electrically noisy building with other motors on the same circuit, so a line conditioner was required.
I am able to make 50 parts at a time and keep them within plus or minus .0015" most of the time.
Ron and Nick at Flashcut are super helpful, they really went out of there way to help when I had questions or issues to work through. I always got an email back in 24hrs. I am a guitar builder and knew nothing about CNC before the purchase.
Good Luck,
Mike |