Originally posted by Ken_Shea
Very interesting Rekd, I recall reading something about that elsewhere (maybe on this board) and totally forgot about it, might be a little much for this single fun project yet very useful down the road. Where can I get ideas on the design?
CNCzone is one very, very informative site, I only wish I had more expertise to share on it instead of just taking.
Thanks much
Ken |
There are some web sites out there for basic vacuum setups. Only problem is I dont' like the waffle-board fixtures everyone seems to be hell bent on using. Biggest thing is setting up the vacuum system. The fixtures should be easier. I'll try to look up some info after Ozzfest.
'Rekd teh Inebriated
__________________
Matt
San Diego, Ca
___ o o o_
[l_,[_____],
l---L - □lllllll□-
( )_) ( )_)--)_)
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |