Hi is this delay after the proxy comes on?
Is your CNC a OT-C?
I looked through a ladder I see
TMR - 2 - D0315 (Time Delay For Chuck (5 Sec))
&
TMR - 3 - D0320 (Time Delay For Chuck (3 Sec))
I do not have an 'L' PMC manual so I can't check but I expect the D indicates it is one of the Diagnostic values you need to change. ??
__________________
***********************************************************
*~~Darwinian Man, though well-behaved, At best is only a monkey shaved!~~*
***********************************************************
*__________If you feel inclined to pay for the support you receive__________*
*_______Please give to charity http://www.oxfam.org/en/getinvolved_______*
***********************************************************
Last edited by MysticMonkey; 02-03-2010 at 02:08 AM.
|