What year is the Haas, I found over the years that Gene was nice enought to some time change the wire config.
Uassly on the older machines I have come across.
Some to look at. you can contact haas and they will give if there is a change on your the wire info on waht is crossed.
I do say that haas's have to one of the easiest to connect to.
What state are you in if i may ask?
__________________
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Cadcam
Mastercam Instructor , Programming Consultant and ME (Manufacturing Eng) |