Royce,
Glad to see a cuemaker on board...
You could mail me at
hadjcues@yahoo.com... can't see your mail addy here...
Yeah I believe with the very minimal power requirement and load stress induced by the workpiece your set up would be adequate for the job.
Just wondering though if the leadscrew configuration ( 1/2-10) would be uniform for all the 3 axes.... if I would use a 5/8 what TPI would it be? I plan to use linear bushing instead of rails with a 5/8 or 3/4 for shafts...
Thanks,
hadj