 G Code to Galil (DMC) converter | |
[QUOTE=Al_The_Man;140800]Are you looking for just the G code translator, or something that includes an operator interface?
The Galil one is just a converter.
Some years ago, Galil were selling an operator interface (OPINT) that unfortunately got dropped , I believe one of the reasons was it was DOS based, It was a great little interface that had alot of potential. I still use it to this day but will only work on the legacy products. If it had been developed to included G code translator it would have been great, screens can be drawn in seconds.
The beauty of it was is, it down loads Galil native language files.
Hello Al,
I just came across this post today. I would like to build a CNC machine using my Galil controller (I have a DMC 730 & a 2030). I also have some small servo drives & motors (Yaskawa SGDA-08AS with SGM-08A 3YG11). I also have a couple of old PC's that can run DOS. The bit I'm basically missing is a G Code to Galil converter, I see in this (old) post that you use one. Could you please advise where I could get a copy of this software? It is only for my home built hobby machine!
Best Regards
Greg  |