If I'm not mistaken, you'd have to read thru the NCI and write all the speeds to a buffer file, then spit them out in the tool table. (More complicated than it sounds if you've never done it.)
You might be able to piggy-back the buffer for the tool callouts, but I'm not sure.
__________________
Matt
San Diego, Ca
___ o o o_
[l_,[_____],
l---L - □lllllll□-
( )_) ( )_)--)_)
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |