I have been on the phone with different Hardinge techs and no one has a clue on how to ressolve this issue. all of them say that it is strange how the main spindle is that far off out of sync. The M7 code is used to put the Main and sub spindle in phase. There is no phase problem so, that code won't work. I have to figure out how to adjust the Fanuc parameters for the speed offset of the main spindle. I located a couple Fanuc maintenance manuals for this controller. (YEAH) i am going to read through them to see if the answer to my problem is hidden in those pages.
Thanks for you response,
Mr Wilson |