Before machining a pocket, which do you think would be handiest:
a) Drill a hole full depth with a different tool. Then begin the pocket with the tool at the hole location.
b) Make a continuous feed plunge to the depth of the initial roughing cut (no chip break) with the current tool.
c) Make a peck feed, chip breaking plunge to the depth of the initial roughing cut with the current tool. (Remember, this option includes the option for 1 peck).
d) Create an entry ramp with a hammer and a cold chisel
Don't be afraid to vote. Your thoughtful opinion is as good as the next guy's.... er.....person's (Hi Jennifer)