How do I gang axes? X X Y Z not working. | |
Ok, I have the machine hooked up (an XYZ plasma cutting table) but I can't seem to get emc.run to configure properly. I want an "X X Y Z" setup but all I get is "X Y Z A". I know it's reading the config file I'm editing because I can change the previous line, the number of axes, from 4 to 3 and the GUI changes. The GUI isn't correct to the manual either, because it has "0 1 2 3" down the left instead of "X Y Z".
Does anyone know what I'm doing wrong? I can't find anything about ganging axes anywhere.
Thor |