I have finally been able to work on my plasma cutter. I have everything connected that I can think of.
But I still can't get it to move.
I am using a BOB from Candcnc, and the parallel interface board, and the 4 VSD's.
I installed the parameters in GDtool for the interface board, and I installed the jumper to disable the charge pump.
The Blue LED is on, so the drives are in the ready condition.
Using a multi-meter I can see a 5 volt change when I press the arrow keys on Mach. I see this 5 volt change on the MTA BOB from CandCNC. This MTA BOB is what connects to the Parallel interface Board.
Am I missing an drive enable or something else?
Do I need to connect anything else?
I will try to upload a picture of the wiring tonight when I get home.
Thanks for the help
Steve