Sounds like a country song!
Actually looking for opinions or experiences setting up ballscrews without parting with too much dough. In particular I'm considering Roton products:
http://www.roton.com/Mating_Componen...family=7059321
I have seen some fancy arrangements using two ballnuts with a spring washer, but this is for an X2 mill so size is an issue. I'm guessing the preloaded ballnut is the answer.
Can anyone share their experience with using the Roton ballscrew and ballnut described above in either the original configuration (non-preloaded) or an 'upgraded' version?!?! Also if anybody has purchased a preloaded ballnut from Roton lately can you share the cost?
TIA --4ist