WSS sorry about adding to your build time (not really - grin). Glad to hear you think enough of some of some of my brain farts to maybe use them. I looked at a lot of builds, checked out a lot of the already built commercial units then just did it my way! So far I have no complaints about the table other than I wish I had been more of an electronics person. The electronics gave me more problems than anything else and the CandCNC packages are a lot easier to use than most others I looked at. If I had bought individual electronic parts I don't think I would have ever been able to get it going. But it is running and I love it.
My table is just A36 steel for the water table and I have seen NO rust at all. Using stainless would be way overkill in my opinion and a lot more $$.
Inccidentally folks if you do not have a water table and are getting plasma dust in your shop while cutting I really hope you are wearing a respirator. That dust is NOT good for your lungs.
Last edited by plain ol Bill; 08-28-2009 at 05:43 PM.
Reason: Added respirator info.
|