Hello Anyone,
I have been a bit stuck on how to proceed with this build.
I think I will have some difficulties getting dedicated Al components machined up as side frames for the gantry. I have had a long look at using 80/20 because I think it may require less machining in order to get to a usable machine.
Any opinions on this, or the relative cost?
I would prefer to not do a detail CAD drawing of components as I would need to learn CAD for real so the flexibility of designing it as I build has some appeal.
Again has anyone done this sort of 'Make it up as you go along' process and what are the pitfalls of it.
Thanks
Jason |