Thanks Andrew!
After you mentioned it, I think I remember something in one of the tutorial videos about using Verify to check your code. I'll have to go back and watch that one again. I'm not sure where I got the idea that it checked for lost steps, but I think I read something about it on this or another forum
Since I posted my original questions, I came up with one more. I recently experienced a phantom limit switch event. I use shielded cable for my limit switches, but, I guess I'm still getting some electrical noise from somewhere. In my reading, I've found that setting a "Debounce" value can correct this problem. One thing about setting this value was asked in one of the posts that I read, but was never answered. Is there a downside to setting this value TOO high?