These are my first 3 attempts to run some code (sent to me by a friend) and see that everything works. The first one, I didn't have a V-bit to cut, so i just used a 1/4" flat endmill (yeah, I couldn't wait till the next day to get the right bit, ha). I forgot to rename my license file, so it was stopping after line 500. The second one was with the v-bit on a piece of MDF I had in my scrap pile. This one showed that I had x-axis reversed and IJ mode set incorrectly. The last one looks pretty good, but I'm losing steps in the x-axis for some reason. I'm still trying to troubleshoot this issue. I'd like to give a special thanks to Jeff Birt who sold me all of the cnc equipment. His support has helped me get this far pretty quick, considering I've only been able to spend a couple hours a week on this project. |