Wow, that's got to be one of the most complete lists I've seen!
Let's see...
The inspection kit has a dial test indicator, but as it's only a small portion of the $60 kit it probably isn't too good. I figure that's why you're buying another.
You're buying drill bits but I don't think you have a drill chuck. You can get them from Taig dealers like cartertools.com .
The clamping kit looks nice, too bad it's M5 threads instead of 10-32 (the Taig uses 10-32 bolts for a lot of stuff). I unfortunately don't know where you can get 10-32 T-nuts, much less a whole kit like that.
The 3" screwless vise might be a little small (specially if you're looking to do 2x4s). If I were buying a vise right now I'd get this one...
http://www.shars.com/products/view/1...ers_Vise_5quot
I'm short on time now but check my posts here for my reasoning...
http://www.cnczone.com/forums/showthread.php?t=77319
There's some more Taig/vise talk here...
http://www.cnczone.com/forums/showthread.php?p=610242
Those parallels look fine, but you might want to check out the parallels Shars has for sale.
I'll come back when I gots more times.