I bought a ton of stuff from Grizzly and was very happy until I needed a replacement gear for the power feed on my lathe. It's been on backorder for TWO MONTHS and is really starting to tick me off having to manually feed the lathe!
Little machine shop. com has a four jaw chuck as well as the other parts your looking for in stock. I also see a ton of them on E-Bay every day and sell pretty cheap. I just bought a 3" four and three jaw chuck for $65.00 shipped from a seller on E-Bay to use on my rotary table.
Here is my 9X20 and some of the tooling. I find it easier and faster to swap out the tail stock chuck for another one rather than re chucking a bit when making the same part over and over again.
Dale P. |