Thanks, sounds like it may work fine. The biggest cases that I've heard of are 60mm diameter, I think plenty small enough for a taig then. The tolerances that I've seen mentioned in watch forums is .05mm, so this seems reasonable as well. The only real draw back that I've read here is that it may be a rather slow going process on a Taig. I only think I will be producing a handfull of any one design, so I will live with it till funding for something bigger comes along.
Only question at the moment is, for the task, is this the best bang for the buck? Not really familiar with what else I might find. Seems like going used might bring more choices, but scrolling through classifieds does little for me when I don't know what I'm really looking at. |