Anybody else using this program? I have just started to play around with it. I am trying differnt settings. The picture here cut the name Travis Timber lake at .040 and cut it at 30IPM. But i had the precision set lower like 2 I think. I bet the edged would be better if I set it to 8. I'll Try that tomorrow.The upside down Bill was cut with a bigger cutter and set on a high precision. Still need to play around somemore with the program. But I can see that the bill one came out more smooth on the edges. So it must be the percision setting!? 
__________________
My little piece of the web!
http://users.adelphia.net/~wjdupont
Last edited by WOODKNACK; 06-18-2003 at 11:52 AM.
|