Spindle Drive - CNCzone.com-The Largest Machinist Community on the net!

09-17-2007, 11:07 PM

ishaham

Join Date: Sep 2007

Location: Michigan

Posts: 11

Spindle Drive

permalink

I am retrofiting Makino A55 with Numatix control, the machine has integral Spindle motor, the motor is 26S 12000RPM,

I would like to use the same motor but I have to use ANALOG drive, is this posible?

Thanks

« Previous Thread | Next Thread »

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are On Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Sweo spindle drive? new mill dead spindle	Shizzlemah	Fadal	13	12-18-2008 12:11 PM
interact 4 spindle drive won't turn on spindle	0041601	Bridgeport and Hardinge Mills	7	06-23-2008 06:51 PM
GE spindle drive	69owb	General Electronics Discussion	6	03-20-2008 01:27 PM
spindle drive	mark c	General Electronics Discussion	10	04-12-2005 10:53 PM
Could one of these be used for a spindle drive	Stevie	General Electronics Discussion	1	01-25-2005 11:13 PM

All times are GMT -5. The time now is 05:36 AM.