Hi, I have a Howa lathe with a Fanuc 5T controller. I have just managed to get a post working, to make code with Mastercam, but the G2 & G3 commands are sometimes causing it to alarm, due to the I & K numbers, not being exactly as it wants. If I change it by .01 mm it may work, or .02 etc. Is there a parameter setting that de-sensifies this, so it allows more leeway in the figures?
Even with hand generated code, it has always been fussy with the I & K amounts, not excepting the nearesr rounding. Sometimes wanting it rounded up, sometimes rounded down.
Does anyone have any suggestions? I will be very greatful.