Need Help! 5T with UCM BTR card communications settings - CNCzone.com-The Largest Machinist Community on the net!

08-13-2010, 12:16 PM

gotham_gollum gotham_gollum is offline

Join Date: Aug 2010

Location: usa

Posts: 1

gotham_gollum is on a distinguished road

5T with UCM BTR card communications settings

permalink

Can anyone tell me the dip switch settings for the communications port on a UCM tape reader card? I have tried every combination of Baud rate,parity & stop bits but when I try and read memory all I get is gibberish.

« Previous Thread | Next Thread »

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are On Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Need Help!- communications help	goaler	Okuma	1	01-30-2010 10:07 AM
Need Help!- COMMUNICATIONS SETTINGS NOT SAVED	CNC_BOB	Mastercam	3	12-29-2009 05:44 PM
Need Help!- Communications from PC to CNC	cncamo	Mazak, Mitsubishi, Mazatrol	2	12-14-2009 11:32 AM
Need Help!- Mach3 CV settings vs. G-100 Plugin CV settings	Bfarn	Machines running Mach Software	7	12-17-2008 10:45 AM
PDA Communications	rfmerrill	General Metalwork Discussion	0	02-09-2005 07:03 PM

All times are GMT -5. The time now is 06:16 PM.