What is your setup in turbocnc 4 | |
I have had more then a few problems setting up for the new turbocnc. But what i am looking for is should my driver be half step or full. If anyone can tell me what setup they have that is working for them then i can basically go from there. As right now i am using a cwtech board design with ucn5804b chips. I have 45 in/oz steppers running 3/8 by 16" i think " allthead. My settings in turbocnc is 0.0001525 for the setting then max them to 1000mhz. I am running under freedos, on its own partition. It seems to operate okay but i'm wondering if things can work better. Basically i would like to know what other people have as a setup and how well it is working for them. Any info will be greatly appreciated. Thanx. |